Fisher & Paykel Dishdrawer DD60SI Preparation And Installation Manual

Integrated panel

Hide thumbs Also See for Dishdrawer DD60SI:

Installation manual (48 pages)

Table Of Contents

Quick Links

Integrated panel preparation

DD60SI and DD60DI models

Dishdrawer®

NZ AU GB IE

Table of Contents

Need help?

Do you have a question about the Dishdrawer DD60SI and is the answer not in the manual?

Questions and answers

Summary of Contents for Fisher & Paykel Dishdrawer DD60SI

Page 1 Integrated panel preparation DD60SI and DD60DI models Dishdrawer® NZ AU GB IE...
Page 2: Safety And Warnings
Safety and warnings WARNING! Electrical Shock Hazard WARNING – To reduce the risk of electric shock, fire, or injury to persons, the installer must ensure that the DishDrawer® is completely enclosed at the time of installation. Before fitting the integrated panel(s) and connecting the integrated badge, make sure that the DishDrawer®...
Page 3: Table Of Contents
Contents Double models Product preparation Single models Product preparation Panel installation Badge cut-out, handle, and panel bracket Securing the panel bracket(s) Reconnecting the wires and fitting the panel(s) and a custom toe kick (double models only) Important! SAVE THESE INSTRUCTIONS The models shown in this document may not be available in all markets and are subject to change at any time.
Page 4: Product Preparation
Product preparation DD60DI models min. 2 mm 8 mm Air gap height of toe kick panel min. 12 mm Installation diagrams for illustration purposes only The following calculations assume the top of the upper panel is aligned with the top of the adjacent cabinetry.
Page 5 Product preparation Toe kick preparation height of toe kick panel Measure D (height from the top of adjacent cabinet door fronts to the fl oor) and write it in the fi rst box below, then complete the equation. height toe kick panel height toe kick panel - 735 mm - 12 mm =...
Page 6: Product Preparation
Product preparation DD60SI models min. 2 mm 9 mm Air gap 9 mm Air gap Installation diagrams for illustration purposes only The following calculations assume the top of the panel is aligned with the top of the adjacent cabinetry: width of the panel Measure A (the width between adjacent door/drawer fronts) and write it in the fi rst box below, then complete the equation.
Page 7: Parts Supplied
Product preparation o o r l e v e l r ® n e a r f l i s h D r a w e n g t h e D i f i n s t a l l i d i a g r a m U s e t h i s 9 mm...
Page 8: Badge Cut-Out, Handle, And Panel Bracket
Badge cut-out, handle, and panel bracket Installation diagrams feature double models for illustration purposes only Important! Ensure the product is not plugged in.
Page 9: Securing The Panel Bracket(S)
Securing the panel bracket(s) 16 mm x6 Double models only: Important! Break off the tab at the top of the Lower Panel Bracket.
Page 10: Reconnecting The Wires And Fitting The
Reconnecting the wires and fi tting the panels and a custom toe kick (double models only) WARNING ! Electrical Shock Hazard Connect the integrated badge ground (earth) wire to one of the two tabs provided on this panel bracket. To ground (earth) the panel bracket, connect the ground (earth) wire from the product to the other tab.
Page 12 Copyright © Fisher & Paykel 2009. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.

This manual is also suitable for:

Dishdrawer dd60di