Winbond Superio Device - JETWAY 613CN User Manual

USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
USB peripherals. The settings are: Enabled, Disabled.
USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
AC97 Audio
This item allows you to decide to enable/disable the OnBoard AC 97' Codec chip to support
Audio function. The settings are: Auto, Disabled.
Game Port Address/Midi Port Address
This will determine which Address the Game Port/Midi Port will use.

3-7-3 Winbond SuperIO Device

CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
POWER ON Function
KB Power ON Password
HOT Key Power ON
Oboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
RxD , TxD Active
IR Transmission Delay
UR2 Duplex Mode
Use IR Pins
Onboard Parallel Port
Parallel Mode
EPP Mode Select
ECP Mode Use DMA
PWRON After PWR-Fail
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has no
floppy drive, select Disabled in this field. The settings are: Enabled and Disabled.
Winbond SuperIO Device
BUTTON ONLY
Enter
Ctrl-F1
Enable
3F8/IRQ4
2F8/IRQ3
Normal
Hi,Lo
Enabled
Half
IR-Rx2Tx2
378/IRQ7
SPP
EPP1.7
3
Off
F6:Optimized Defaults
34
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults