Reload Timer Events - JETWAY 613CN User Manual

DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake Up by PCI card
This will enable the system to wake up to PCI LAN Card.
The settings are: Enabled and Disabled.
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 12.5%, 25.0%, 37.5%, 50.0%,
62.5%, 75.0%, 87.5%.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.

Reload Timer Events

Please refer to section 3-8-1
3-8-1 Reload Timer Events
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Primary IDE 0
Primary IDE 1
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
Reload Timer Events
Disabled
Disabled
37
Item Help