Onchip Superio Device - JETWAY A210GDAG User Manual

3-7-3

OnChip SuperIO Device

Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Mode
x ECP Mode Use DMA
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first and the second serial ports. The settings
are: 3F8/IRQ4, 3E8/IRQ4, Disabled, Auto.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,
and EPP features. It has the following option:
Disabled
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose "SPP." To
operate the onboard parallel port in the EPP modes simultaneously, choose "EPP." By
choosing "ECP", the onboard parallel port will operate in ECP mode only.
"ECP+EPP" will allow the onboard parallel port to support both the ECP and EPP modes
simultaneously. The ECP mode has to use the DMA channel, so choose the onboard parallel
port with the ECP feature. After selecting it, the following message will appear: "ECP Mode
Use DMA" at this time, the user can choose between DMA channels 3 to 1. The onboard
parallel port is EPP Spec. compliant, so after the user chooses the onboard parallel port with
the EPP function, the following message will be displayed on the screen: "EPP Mode Select."
At this time either EPP 1.7 spec. or EPP 1.9 spec. can be chosen.
Phoenix – AwardBIOS CMOS Setup Utility
OnChip SuperIO Device
F6:Optimized Defaults
Line Printer port 0
Line Printer port 2
Line Printer port 1
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Half
378/IRQ7
SPP
3
30
Item Help
Menu Level >>
F7:Standard Defaults
Choosing