Expansion Card - JETWAY 613CN User Manual

This motherboard provides
(DIMM) sites for memory expansion available from minimum memory size over
32MB to maximum memory size of 512MB SDRAM.
Valid Memory Configurations
DIMM1 DIMM2
DS/SS
DS/SS
DS : Double Sided DIMM
NOTE! Make sure the total installed memory does not exceeds 512MB, otherwise
the system may hang during startup.
Generally, installing SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 168-Pin PC100 & PC133 SDRAM module looks like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING! For the SDRAM CLOCK is set at 133MHz, use only PC133-compliant
DIMMs. When this motherboard operate at 133Mhz, most system will
not even boot if non-compliant modules are used because of the strict
timing issues, if your DIMM are not PC133-compliant, set the
SDRAM clock to 100MHz to ensure system stability.
2-5 Expansion Cards
two 168-pin DUAL INLINE MEMORY MODULES
System Accept or Not
DS/SS
DS/SS
SS : Single Sided DIMM
Accept
Accept
Accept
Figure 2-4
13
Total Memory
Min.  Max.
32MB256MB
32MB256MB
32MB512MB