Winbond Superio Device - JETWAY 630BF User Manual

This will determine which Address the Game Port/Midi Port will use.
AMR Modem DEVICE
This item allows you to decide to enable/disable the chipset family to support AC97 Modem.
The settings are: Auto, Disabled.
USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
a USB peripherals. The settings are: Enabled, Disabled.
USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
ETHERNET Address ID Input (Only for 630BF)
This item allows you to setting the Mac address from 003018 to 000001.

3-7-3 Winbond SuperIO Device

CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
RxD,TxD Active
IR Transmission Delay
IR Duplex Mode
Use IR Pins
Onboard Parallel Port
Parallel Port Mode
EPP Mode Select
ECP Mode Use DMA
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install add-on FDC or the system has no floppy drive,
select Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Winbond SuperIO Device
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Hi,Hi
Enabled
Half
IR-Rx2Tx2
378/IRQ7
SPP
EPP1.9
3
F6:Optimized Defaults
34
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults