Hardware Installation Steps; Checking Motherbaord's Jumper Setting - JETWAY 613CN User Manual

2-1 Hardware installation Steps

Before using your computer, you had better complete the following steps:
1. Check motherboard setting
2. Install CPU
3. Install Memory
4. Install Expansion cards
5. Connect Ribbon cables, Panel wires, and power supply
6. Setup BIOS
7. Install software driver & utility
2-2 Checking Motherboard's Jumper Setting
1. CPU & SDRAM Clock setting : JP6, JP7, JP17, JP18
The motherboard's CPU & SDRAM memory clock adjusted through jumper JP6,
JP7, JP17, JP18 Table as below:
CPU/SDRAM (MHz)
AUTO
66/100
100/100
133/100
Only for 613CN/613CF
2. Keyboard Power On Function setting (3-pin): JP3
This allows you to disable the keyboard power on function. Set the jumper to
enabled or disabled if you wish to use your keyboard (by pressing < >) to power on
your computer, this feature requires an ATX power supply that can supply at least
300mA on the +5VSB lead. The default is set on disable.
3. Clear Keyboard Power On password setting (3-pin): JP2
JP6 JP7
1-2 1-2
2-3 2-3
2-3 1-2
1-2 1-2
7
JP17 JP18
ON ON
OFF OFF
OFF OFF
OFF OFF
* Default