Teledyne T3CP100-2 Manual page 8

High / Low Range Selection Table
This table indictes to the user the ranges of the high and low settings as well as the output voltage
level.
Auto Zero Indicator
The Auto Zero indicator will be alight when the probe is running it's auto zero process.
Auto Zero Button
Pressing the Auto Zero Button starts the degaussing and auto zero process. The auto zero
indicator will alight during this process. The probe measurement clamp jaw should be disconnected
from any DUT before using the auto zero button. It is recommended to use the auto zero button
before making any measurements.
Control Unit
The control unit houses the probe control as well as having a 9V battery compartment. A standard
9V alkaline battery needs to be installed within the battery compartment if using the probe without
the external power supply.
1m Interconnect Cable
The 1m current probe head / control unit interconnect cable is permanently attached between the
probe head and the control unit.
Probe Head
The current probe measurement head uses a spring loaded lever to open and close the jaw. The
jaw can clamp around cables up to 12mm in diameter. The measurement cable / DUT should
always be insulated. Do not clamp around uninsulated wires and cables.
BNC Output Connector
The BNC output connector can be connected to any instrument with a 1
including an Oscilloscope, DVM / DMM,
connection if the measuring instrument has a BNC input, such as an Oscilloscope. If connecting to
a DVM / DMM then a BNC to banana plug cable may be required (not supplied), see your DVM /
DMM manual.
Power Supply
The supplied wall socket power supply (not illustrated) can be used to power the T3CP100-2
current probe in place of batteries if required.
etc. The supplied BNC to BNC cable can be used for this
1m BNC to BNC Output Cable
Page 5
MΩ input impedance