Teledyne T3CP100-2 Manual page 11

T3CP100-2 Specifications (continued)
Maximum Insulated Wire Voltage
Typical Battery Life
Low Power Indication
Overload Indicator
Calibration Interval
Warranty
Parameter
DC
DC + Peak AC
AC Peak
AC Peak to Peak
RMS CAT I
RMS CAT II
RMS CAT III
Safety Ratings
1
Probe Designation
Measurement Category
3
Safe Voltage Rating
4
Pollution Degree
Definitions (per IEC/EN 61010-2-032:2019)
1. Type D current probe is intended to be applied around or removed from insulated conductors.
2. O refers to other circuits not intended to be directly connected to the Mains supply. Not rated for
measurements within Measurement Categories II, III, or IV.
3. Not rated for measurements on uninsulated conductors.
4. Pollution Degree 2 refers to operating environment where normally only dry, non-conductive
pollution occurs. Temporary conductivity caused by condensation must be expected.
Voltage And Current Rating Table
Maximum Operating Current
Low Range
10A
10A
10A
20A
7.07A
7.07A
7.07A
Type D
2
O (Other)
Use only on fully insulated conductors
2
Low Range
CAT II 600V, CAT III 300V
9V Alkaline: 15 Hours
At <6.5V the battery indicator will turn red
When the measurement current exceeds the probe range the buzzer
High Range
100A
100A
100A
200A
70.7A
70.7A
70.7A
Page 8
High Range
will buzz
Annually
1 Year
Maximum Maximum
Operating Floating
Voltage Voltage
600V 600V
600V 600V
600V 600V
1200V 0V
600V 600V
600V 600V
300V 300V