Circontrol Wallbox eNext Series Installation Manual page 8

WallBox eNext Installation Manual
2
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
The charge point is designed for installation in indoor and outdoor areas. For each of
the different conditions of installation, the unit must be installed safely and assuring
the adequate protections.
• Charge point must not be installed
in areas where potential risk of
explosions are.
• Do not install the charge point
where falling objects may damage
the equipment.
• The surface where the charge
point is placed must withstand the
mechanical forces.
• This unit is no shall be used for
anything
electric vehicle charging modes as
are expected in IEC 61851.
• Do
modified, Circontrol will reject all
responsibility and the warranty will
be void.
• Comply
safety regulations according to your
country.
• Do not use any adapter, except those
approved by the EV manufacturer
Refer to TECHNICAL DATA section for more information about environmental
installation conditions.
04
Read carefully all the instructions before starting in or-
der to ensure properly installation of the charge point.
other purpose
not modify this unit.
strictly with electrical
• Do not perform any repair o
manipulation of the unit while it is
energized.
• Only trained and qualified personnel
should be able to access to low-
voltage electrical parts inside the
unit.
• Check the installation annually by
qualified technician.
• Remove from service any item
than which have a fault that could be
dangerous for users (broken plugs,
caps that don't close...).
If • Use only Circontrol supplied spare
parts.
• Do not use this product if the
enclosure or the EV connector is
broken, cracked, open, or shows
any other indication of damage.