Circontrol Wallbox eNext Series Installation Manual page 14

WallBox eNext Installation Manual
5
Material:
•
•
•
Tools:
Screw driver
(*) Ratchet tool can be used to open/close the charge point if the conditions of the installation
requiers it
10
Allen wrench of 2,5 mm is included in the installation kit.
Screws, sealing washers and plastic anchors are not included.
The fastening system of the charge point has been designed to be
installed on a wall.
» This system has been tested on a concrete wall, to be securely
fixed in such conditions is recommended to use:
3 x Inox A2 wall screws: DIN 7982 Ø4,8x38 or DIN 7981 Ø4,8x38
3 x plastic anchors: 6x40 or 8x40
» If the wall surface has different properties, the screws and plastic
anchors must be defined by a qualified installer.
Ratchet*
2.5mm Allen
Driller
Tap drill 6/8M