ETC User Guide
QuickTouch Preset
WARNING:
AVERTISSEMENT :
de cet équipement.
WARNING:
capacity that a user may apply to that device or system.
All ETC Rigging hoists have a Working Load Limit. This is identified on the
product label on the back of the hoist and on the batten label. This limit is not
the same for all hoists; be sure to check the Working Load Limit for all hoists in
your system. Prodigy Working Load Limits include a design-safety factor.
If you cannot find a Working Load Limit for any device under the control of the
ETC Rigging system, do not operate and contact your ETC Rigging installer.
NEVER exceed the Working Load Limit for any hoist.
WARNING:
Working Load Limit (WLL) for any line set. See label on batten for POINT, UDL,
and WLL. Point, distributed, and working load limits may be different for each
device.
Do not suspend persons from the device or any of its components. Do not ride
on the batten.
Stop use of the system immediately if unusual noises are heard or unusual
smells are detected during operation. Contact a qualified ETC Rigging inspector
before resuming use.
In the event of an Emergency Stop (E-stop) cease use of the system, identify
who engaged the E-stop and why, and resolve the issue before restarting the
system.
Never lock or jam the operating buttons in the depressed ("on") position. These
hold-down buttons must be operated by a competent person at all times. Log
out or remove the enable key of this rigging controller when a competent or
qualified person is not present.
Use a remote unit when the load is obscured from this operator position or have
someone observe the load while it is moving. Never leave the controller when a
hoist is in motion.
Prior to servicing the system, disconnect and lock out/tag out power (according
to NFPA Standard 70E) to any relevant components.
Always inspect and test the ETC Rigging system before each use.
Have certified ETC Rigging inspector perform regular inspection and
maintenance as dictated by the system installer, ETC's specifications, and
warranty agreements. The system must be inspected annually by a qualified ETC
Rigging inspector.
QuickTouch Preset
Disconnect power before servicing this equipment.
Déconnectez l'alimentation avant d'effectuer l'entretien
The Working Load Limit (WLL) of any device is the maximum load
Do not exceed point load, Uniform Distributed Load (UDL), or
Page 3 of 15
ETC
Need help?
Do you have a question about the QuickTouch Preset and is the answer not in the manual?
Questions and answers