Polaris RANGER 2x4 Manual page 191

FINAL DRIVE
6. Remove the bolts from the input cover (H).
7. Remove the input cover bolts (I). Remove the input
cover (H) and pinion gear assembly from the
gearcase.
H
8. Remove the pinion gear (J) assembly from the front
cover (H). If the pinion gear does not come loose
from the front cover, use the following steps to aid
in removal:
S
Hold the pinion gear assembly
S
Use a rubber mallet to lightly tap
around the bearing cup of the front
cover
S
Tap the front cover in an X pattern
(follow the pattern in the photo on the
right), until the pinion gear assembly
comes loose
H
I
J
9. Inspect the pinion gear (K) and 26T output gear (L)
for nics or uneven wear. Inspect the bearing (M),
the bearing should spin smoothly. Replace the
parts as needed.
K
10. Remove the rear output seal (N).
H
1
3
4
2
L
M
7.33