Polaris RANGER 2x4 Manual page 182

6. Remove the upper control arm bolt.
7. Remove the both lower A--arm bolts.
8. Remove the bearing carrier from the A--arm
assembly.
Bearing
Carrier
MIDDLE HUB INSTALLATION
(6X6)
1. Start bearing carrier on drive shaft.
2. Align bottom of carrier housing and lower control
arm. Grease and slide lower control arm
bushings into place, securing corner housing.
7.24
3. Install and torque both lower control arm bolts.
Lower Control Arm Bolt Torque:
40 ft. lbs. (54 Nm)
Upper Control Arm Bolt Torque:
40 ft. lbs. (54 Nm)
4. Lift bearing carrier until top aligns with upper control
arm. Install and torque upper control arm bolt and
torque to specification.
FINAL DRIVE