Polaris RANGER 2x4 Manual page 183

FINAL DRIVE
5. Pull drive shaft outward and install hub onto
driveshaft splines.
6. Install the washer (A) and the cone washer (B) with
domed side facing outward. (Refer to next photo)
Cone
Washer
7. Install retainer nut (C), wheel and wheel nuts.
B
8. Remove jackstand and torque the rear hub nut to
100 ft. lbs. (138 Nm) and wheel nuts to 20 ft. lbs.
(27 Nm).
Out
A
C
Rear Hub Nut Torque:
110 ft. lbs. (149 Nm)
Rear Wheel Nut Torque
35 ft. lbs. (47 Nm)
9. Install a new cotter pin. Tighten nut slightly to align
holes if required.
10. Install hub cap.
MID DRIVE BEARING
CARRIER / HUB
DISASSEMBLY (6X6)
1. Remove outer snap ring (A).
A
2. From the back side, tap on the outer bearing race
with a drift punch in the reliefs as shown.
NOTE: Drive bearing out evenly by tapping on outer
race only. Once bearing is at bottom of casting,
support casting on outer edges so bearing can be
removed.
7.25