Polaris RANGER 2x4 Manual page 174

5. Remove the roll cage assembly, rollers, and
H--springs.
6. Thoroughly clean all parts. Inspect the rollers (A)
for nics and scratches. The rollers must slide up
and down freely within the roll cage sliding
surfaces (B).
7. Inspect the ring gear (C) for consistent wear
patterns. The surfaces should be free of nics and
scratches.
C
8. Inspect roll cage (B) sliding surface. This surface
must be clean and free of nicks, burrs or
scratches. Remove and inspect the H--springs.
7.16
9. Remove the ring gear (C), the output hub (D), the
10. Inspect the armature plate (F) for a consistent
B
A
11. Remove the thrust bearing (G) from the output
B
shim (E), and the armature plate (F) from the
output cover.
wear pattern. Uneven wear of the armature plate
(F) indicates a warped plate, which may cause
intermittent operation.
C
E
F
hub (D). Inspect the thrust bearing (G) and the
dowel (H).
FINAL DRIVE
H--spring
D
Coil