Table of Contents
Advertisement
Allegro 20 Disc Publishing System
Service Manual
18.5
Pull out on left end of carrier shaft to pop it out of carrier frame. Slide carrier off of shaft and
remove from unit.
18.6
When replacing carrier, be sure picker and carrier are properly captured on top edge of carrier
frame. Press carrier shaft back into frame, tightening both screws at the same time to prevent it
from spinning. Be sure flex cable is parallel with frame for before securing flex holder. Be sure
belt is not twisted. Pull encoder strip back into sensor slot on back of carrier.
Rimage Corporation
Page 30
Advertisement
Table of Contents
