Platform Support; Cisco Ios Packaging; Boot Rom Requirements; Cip Boot Image Requirements - Cisco 11.0 BT Release Notes

Platform Support

Cisco IOS Release 11.0 BT supports the following router platforms:
•
Cisco 7500 series
•
Cisco 7000 series and Cisco 7000 series with RSP7000

Cisco IOS Packaging

The following feature sets are available in Release 11.0 BT. Refer to the Router Products Release
Notes for Cisco IOS Release 11.0 for a list of the features provided in the Cisco 7000 and Cisco 7500
series feature sets.
•
Enterprise (this feature set includes CIP)
•
Enterprise/CIP2

Boot ROM Requirements

Boot ROMs that support Cisco IOS Release 11.0 are required. No special requirements exist for
Cisco IOS Release 11.0 BT.

CIP Boot Image Requirements

The CIP boot image is bundled in the Cisco IOS Release 11.0 BT image. You must have the image
that supports your CIP or your CIP2 hardware. You cannot run a CIP and a CIP2 card in the same
router. See Table 1 for a list of image names and supported CIP or CIP2 cards.
Table 1
Image Names
rsp-k-mz
rsp-k2-mz
gs7-k-mz
gs7-k2-mz

Memory Requirements

The memory requirements for Cisco IOS 11.0 BT are shown in Table 2. The CIP supports up to
128 Mb of memory.
Table 2
Cisco 7500 Series
and Cisco 7000
with RSP7000
Enterprise Set
(rsp-k-mz)
Enterprise/CIP2 Set
(rsp-k2-mz)
Cisco IOS Release 11.0 BT Release Note and Update to Configuration Guides and Command References
11.0 BT Image Names for CIP and CIP2 Hardware
Supported CIP Hardware
CIP
CIP2
CIP
CIP2
11.0 BT Memory Requirements
Minimum Required
Code Memory
8 MB Flash memory
card
8 MB Flash memory
card
Required Main Required CIP
Memory Memory
24 Mb 32 Mb
24 Mb 32 Mb
Release Note
Release 11.0
Runs From
RAM
RAM
3