Show Extended Channel Tn3270-Server Dlurlink - Cisco 11.0 BT Release Notes

show extended channel tn3270-server dlurlink

show extended channel tn3270-server dlurlink
Use the show extended channel tn3270-server dlurlink privileged EXEC command to display
information about the DLUR components.
Syntax Description
slot/2
name
Command Mode
Privileged EXEC
Sample Display
The following is sample output on the Cisco 7000 from the show extended channel tn3270-server
dlurlink command:
Table 8 describes significant fields in the display.
Table 8
Field
LSAP...VRN...STATUS status
LINK name
LINK...STATUS status
PARTNER name
TGN tg-number
MAXDATA maxdata
44 TN3270 Server Commands
show extended channel slot/2 tn3270-server dlurlink name
Specifies a particular CIP in the router where slot is the slot number.
The port value for a TN3270 server will always be 2.
Name of the SNA session switch link to be displayed.
router# show extended channel 3/2 tn3270-server dlurlink P390
lsap token-adapter 0 5C
link P390
partner MPX.NGMVMPC
Show tn3270-server dlurlink Field Descriptions
vrn MPX.LAN4
remote 4000.7470.00e7 08
tgn 1
Description
Possible sap-status values and their meanings are:
• inactive—Not connected to adapter.
• pnd-actv—SAP activation in progress.
• active—SAP open.
• pnd-inac—SAP deactivation in progress.
Name is an invented name, @DLURnn, if not a configured link.
Possible link-status values and their meanings are:
• inactive—Not connected to host.
• pnd-actv—Link activation in progress.
• active—Link active.
• pnd-inac—Link deactivation in progress.
CP name of the remote node for this link.
Transmission group number for this link. Because the SNA session
switch only supports 1 transmission group per pair of CP names, it
is typically 0 or 1.
Maximum frame size allowed on this link.
status ACTIVE
status ACTIVE
maxdata 1033