Lsap - Cisco 11.0 BT Release Notes

lsap

lsap
Use the lsap DLUR configuration command to create a SAP in the SNA session switch, or to enter
DLUR SAP configuration mode. Use the no form of this command to delete a SAP and all SNA
session switch links using the internal LAN interface.
Syntax Description
type
adapter-number
lsap
Default
The default value for lsap is hexadecimal C0.
Command Mode
DLUR configuration
Usage Guidelines
If the SAP in the SNA session switch function is already created, the lsap command with no
arguments puts you in DLUR SAP configuration mode.
The lsap command can be entered only in DLUR configuration mode.
The lsap command uses values that are defined in two other commands: the lan internal LAN
configuration command and the adapter internal LAN configuration command. The lan type and
adapter adapter-number values configured on the CIP internal LAN interface are used in the lsap
command.
However, the lan type keyword is a little different. Where the type on the lan command is tokenring,
the corresponding type on lsap is token-adapter. This emphasizes that the number that follows is
an adapter number, not a lan number.
The no lsap command hierarchically deletes any links using it. Any sessions using those links are
lost.
28 TN3270 Server Commands
lsap
lsap type adapter-number [lsap]
[no] lsap type adapter-number [lsap]
Internal adapter type on the CIP card, which corresponds to
the value specified in the lan internal LAN configuration
command. The currently supported type is token-adapter.
Internal adapter interface on the CIP card, which is the
same value specified in the adapter internal LAN
configuration command.
(Optional) Local SAP number, 04 to FC, in hexadecimal.
The value must be even and should normally be a multiple
of 4. It must be unique within the internal adapter in that no
other 802.2 clients of that adapter, in the router or in a host,
should be allocated the same SAP. The default value is C0.