Cisco 11.0 BT Release Notes page 12

TN3270 Configuration Modes
DLUR SAP Configuration Mode
From DLUR server configuration mode, lsap command puts you in DLUR SAP configuration mode.
Prompt:
PU Configuration Mode
There are two paths to PU configuration mode: from the TN3270 server configuration mode, or from
the DLUR configuration mode. In either mode, the pu command puts you in PU configuration mode.
From TN3270 configuration mode, the pu command to create a new PU is:
From DLUR configuration mode, the pu command to create a new PU is:
From either mode, to return to PU configuration mode on PU pu-name the command is:
Prompts:
Commands Allowed in Multiple Modes
The following commands are valid in TN3270 configuration mode, or in either variation of PU
configuration mode:
Values entered in PU configuration mode override settings made in TN3270 configuration mode. In
addition, the no form of these commands entered in PU configuration mode will restore the
command value entered in TN3270 command mode.
12 Configuring TN3270 Server on the Channel Interface Processor
tn3270-dlur-lsap>
pu pu-name idblk-idnum ip-address type adapno lsap [rmac rmac] [rsap rsap] [lu-seed
lu-name-stem]
pu pu-name idblk-idnum ip-address
pu pu-name
tn3270-pu>
tn3270-dlur-pu>
[no] tcp-port port-number
[no] idle-time seconds
[no] keepalive seconds
[no] unbind-action {keep | disconnect}
[no] generic-pool {permit | deny}
[no] shutdown