Cisco 11.0 BT Release Notes page 37

Table 5 Show tn3270-server Field Descriptions (Continued)
Field
DISCONN number
FAIL number
RESPONSE TIME, HOST
number
RESPONSE TIME, TCP
number
IDLE-TIME number
KEEPALIVE number
UNBIND-ACTION type
TCP-PORT number
GENERIC-POOL type
DLUR fq-cpname
STATUS
DLUS fq-dlusname
NAME pu-name
IP:TCP ip-addr:tcpport
XID number
STATE value
Description
Total number of disconnects since the TN3270 feature was started.
Total number of failed connects since the TN3270 feature was
started.
The average response time from the host across all sessions through
this server IP address. This is measured from sending CD to the
host to receiving the reply.
Average response time from the clients on this server IP address.
This is measured only when TIMING MARKs are sent. If no
timing-mark is configured, they are only sent on special occasions,
such as Bind.
Configured idle-time for this PU.
Configured keepalive for this PU.
Configured unbind action for LUs on this PU.
Configured TCP port number.
Configured generic-pool for LUs on this PU.
Configured fully qualified DLUR CP name.
Possible DLUR-DLUS status values and their meanings are:
reset—The DLUR-DLUS pipe is reset.
pnd-actv—The DLUR-DLUS pipe is pending active.
active—The DLUR-DLUS pipe is active.
pnd-inac—The DLUR-DLUS pipe is pending inactive.
Currently active DLUS.
This is the name of the PU as configured.
IP address and TCP port number configured for the PU.
Configured XID - idblk and idnum.
Possible STATE values and their meanings are:
• shut—The PU is configured but in shut state.
• reset—The link station of this PU is not active.
• test—PU is sending a TEST to establish link.
• xid—TEST is responded, XID is sent.
• p-actpu—The link station is up but no ACTPU is received.
• active—ACTPU is received and acknowledged positively.
• act/busy—Awaiting host to acknowledge the SSCP-PU data.
• wait—Waiting for PU status from CIP.
• other—PU in undefined state.
• p-rqactpu-r—DLUR PU is pending request ACTPU response.
• p-active—ACTPU received by DLUR but not yet passed to PU.
• p-dactpu—PU is pending DACTPU.
show extended channel tn3270-server
TN3270 Server Commands 37