Removing And Installing A Compact Flash Disk - Cisco PRP-1= Installation And Configuration Manual

Removing and Installing a Compact Flash Disk

Note
Step 1
Step 2
Step 3
Figure 18 Removing the CF from the PRP-2 Board
Step 4
Step 5
OL-11656-01
You must remove the PRP-2 before you can remove or install a compact flash
disk. The compact flash disk is only supported on the PRP-2.
To remove a compact flash disk (CF) from the PRP-2 board, follow these steps:
Loosen the screw fastening the retaining bracket for the CF. (See
Lift the end of the retaining bracket out of the hole that holds it in place flush with
the CF, and swivel it around until it is not in the way of removing the CF. (See
Figure 18.)
Press lightly on the CF and push it out of its socket in the direction of the retaining
bracket. (See Figure 18.)
Once the CF is released from the socket, pull it completely out of the board.
If you are not inserting another CF into the socket on the board, replace the
retaining bracket by swivelling it back around until the end rests in the hole on the
PRP-2 board and fastening the screw into the board.
Performance Route Processor Installation and Configuration Guide
Additional Configuration and Maintenance Tasks
Figure 18.)
67