Cisco PRP-1= Installation And Configuration Manual page 25

Avoid touching the PRP printed circuit board, components, or any edge connector
Caution
pins.
Place the bus-connector edge of the PRP in the appropriate slot and align the
Step 4
notches along the edge of the carrier with the grooves at the top and bottom of the
slot.
While keeping the PRP edge connector parallel to the backplane, carefully slide
Step 5
the carrier into the slot until the PRP faceplate makes contact with the ejector
levers, then stop.
Using the thumb and forefinger of each hand to pinch each ejector lever, push both
Step 6
ejectors simultaneously toward the center of the PRP faceplate until they are
perpendicular to the PRP faceplate. (See
Using a 3/16-inch flat-blade screwdriver, tighten the captive screws on the ends
Step 7
of the PRP. The captive screws prevent the PRP from becoming partially
dislodged from the backplane and ensure proper EMI shielding. (These captive
screws must be tightened to meet EMI specifications.)
If you disconnected cables to remove the PRP, or if you are installing a new PRP,
Step 8
reconnect the cables to the appropriate ports. (See the
section on page
Ensure that the console terminal is turned on.
Step 9
Turn on system power.
Step 10
Attach the network end of your RJ-45 cable to your transceiver, switch, hub,
Step 11
repeater, DTE, or other external equipment. Be sure to use the appropriate strain
relief on cable connections.
OL-11656-01
26.)
Performance Route Processor Installation and Configuration Guide
Removing and Installing a PRP
Figure 6b.)
"Checking the Installation"
25