Installing A Dimm - Cisco PRP-1= Installation And Configuration Manual

Additional Configuration and Maintenance Tasks
Caution
Step 5
Step 6
Step 7

Installing a DIMM

Note
Step 1
Step 2
Caution
Step 3
Step 4
Performance Route Processor Installation and Configuration Guide
78
Handle the edges of the DIMM only. Do not touch the integrated circuit devices
on the DIMM, the metal traces, or fingers, along the edge of the DIMM, or the
pins in the DIMM socket.
As one end of the DIMM is released, grasp the top corners of the DIMM with the
thumb and forefinger of each hand and pull the DIMM completely out of its
socket.
Immediately place the DIMM in an antistatic bag to protect it from ESD damage.
Repeat Step 4 through
This section contains instructions for installing DIMM memory into a line card.
If you are upgrading packet memory, both DIMM sockets of a given pair (either
the transmit buffer or the receive buffer) must be populated with a DIMM of the
same type and size.
To install DIMMs in a line card, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Place the line card on an antistatic mat so that the faceplate is nearest to you.
To prevent router and memory problems, all DIMMs installed in the line card
must be 3.3V devices.
Remove the new DIMM from its protective antistatic bag.
Grasp the edges of the DIMM only. Do not touch the integrated circuit devices on
the DIMM, the metal traces, or fingers, along the edge of the DIMM, or the pins
in the DIMM socket. (See
Step 6 for any remaining DIMMs that you want to remove.
Figure 23.)
OL-11656-01