Upgrading To The Prp - Cisco PRP-1= Installation And Configuration Manual

Upgrading to the PRP

Figure 9 PRP-2 LEDs (Partial Front Panel View)
Upgrading to the PRP
Performance Route Processor Installation and Configuration Guide
32
ETH 0 ETH 1
The PRP-2 has the following LED indicators:
Two Flash disk activity LEDs, one for each Flash disk slot (labeled SLOT-0
•
and SLOT-1)—Identify which of the Flash disk slots is accessed.
Two Ethernet port LEDs used in conjunction with each of the three RJ-45
•
Ethernet connectors:
LINK—indicates link activity
–
DATA—indicates data transmission or reception
–
Two BITS port LEDs used in conjunction with each of the two BITS ports:
•
SIG—indicates carrier signal available
–
ACT—indicates the interface is active
–
This section details how to upgrade from the GRP to the PRP. The procedures
described are the same whether you are upgrading to a PRP-1 or PRP-2.
Upgrading to the PRP Without Rebooting the Router, page 33
•
• Upgrading to the PRP With Rebooting the Router, page 40
Differentiating Between PRP-1 and PRP-2, page 43
•
BITS 0 BITS 1 ETH 2
OL-11656-01