Cisco PRP-1= Installation And Configuration Manual page 71

Within 5 seconds of turning on the router, press the Break key. This action causes
Step 5
the terminal to display the bootstrap program prompt as follows:
Rommon 1>
Step 6 Set the configuration register to ignore the configuration file information as
follows:
Rommon 1> confreg
enabled are:
console baud: 9600
boot: image specified by the boot system command
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]:
enable "use net in IP bcast address"? y/n [n]:
enable "load rom after netbootfails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect?" y/n [n]:
enable "ignore system config info?" [n]: y
change console baud rate? y/n [n]:
change boot characteristics? y/n [n]
enabled are:
console baud: 9600
boot: image specified by the boot system command
Do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
Step 7 Initialize the router by entering the i command as follows:
Rommon 1> i
The router power cycles, the configuration register is set to ignore the
configuration file, and the router boots the boot system image and prompts you
with the system configuration dialog as follows:
Enter no in response to the system configuration dialog prompts until the
Step 8
following system message is displayed:
Press RETURN to get started!
OL-11656-01
Configuration Summary
or default to: cisco2-PRP
Configuration Summary
or default to: cisco2-PRP
--- System Configuration Dialog ---
Performance Route Processor Installation and Configuration Guide
Additional Configuration and Maintenance Tasks
71