Installing And Removing A Flash Memory Card - Cisco Router 7204 Installation And Configuration Manual

Chapter 6 Maintaining the Cisco 7204

Installing and Removing a Flash Memory Card

The I/O controller has two PCMCIA slots for Flash memory cards: slot 0 (lower) and slot 1 (upper).
Complete the following steps to insert a Flash memory card in either PCMCIA slot:
Note To avoid potential problems when inserting spare Flash memory cards in your Cisco 7204, we
recommend that you reformat all of your Flash memory cards on a Cisco 7204 running one of the
recommended Cisco IOS software releases listed in Software Advisor. The section
Flash Memory Card" section on page 6-12
Flash memory card.
Orient the Flash memory card so that its connector end faces the appropriate slot. (Refer to
Step 1
Carefully guide the card into the slot until the card seats in the slot's connector and the eject button for
Step 2
the slot pops out toward you. (Refer to
Note
Complete the following steps to remove a Flash memory card from either PCMCIA slot:
Press the ejector button on the slot. (Refer to
Step 1
Step 2 Grasp the card and pull it from the slot.
Step 3 Place the card in an antistatic bag.
This completes the steps for inserting and removing a Flash memory card.
OL-5101-02
Flash memory cards do not insert all the way into the PCMCIA slots; the end of the card
protrudes from the I/O controller faceplate. Do not attempt to force the card past this point.

Installing and Removing a Flash Memory Card

contains instructions that explain how to reformat a
Figure 6-5b.)
Figure 6-5c.)
Cisco 7204 Installation and Configuration Guide
"Reformatting a
Figure 6-5a.)
6-7