Translated Safety Warnings And Agency Approvals - Cisco PRP-1= Installation And Configuration Manual

Step 14
Step 15
Troubleshooting Upgrade Failures
Regulatory, Compliance, and Safety Information

Translated Safety Warnings and Agency Approvals

OL-11656-01
Now reload the entire system using the reload command.
Once the RP's are up, ensure the RPs are upgraded using show hw-module all fpd
CLI. The CLI should not report the previous discrepancy in versions. Also the
warning message UPGRADE_REQUIRED should not appear in the console
during bootup.
Upgrade failures may cause a corrupted FPGA image to be left in the RP and may
cause the RP to become completely inoperable. In such unforeseen situations, the
card needs to be replaced to proceed further. Recovering the RP is not supported.
SIP/SPA card's FPD recovery is performed from LC and LC/RP can keep running
while the SIP/SPA is corrupted. However, without a proper chopper FPGA image,
it is very difficult to boot the board. If the board fails to come up due to Chopper
FPGA programming error, then the card needs to be replaced.
This section includes regulatory, compliance, and safety information.
Translated Safety Warnings and Agency Approvals, page 83
•
Electromagnetic Compatibility Regulatory Statements, page 84
•
The complete list of translated safety warnings and agency approvals is available
in the Regulatory Compliance and Safety Information for Cisco 12000 Series
Internet Routers publication.
(Document Number 78-4347-xx.)
Performance Route Processor Installation and Configuration Guide
Regulatory, Compliance, and Safety Information
83