Starting The System And Observing Initial Conditions - Cisco PRP-1= Installation And Configuration Manual

Starting the System and Observing Initial Conditions

Step 1
Step 2
Step 3
OL-11656-01
This section describes the initial system startup processes and procedures.
To start your system, follow these steps:
Turn on each installed power supply by turning its system power switch to the on
(|) position.
For AC-input power supplies, the green AC OK LED should go on. For DC-input
power supplies, the green input OK LED should go on. For both types of power
supplies, the output fail LED should be off.
Listen for the system blower modules or fan trays in the router; you should
immediately hear them operating. In a noisy environment, place your hand in
front of the exhaust vents to verify that the blower modules are operating.
During the PRP boot process, observe the PRP alphanumeric display LEDs,
which are located at one end of the PRP, near the ejector lever. (See
The 4-digit displays show system messages and displays a sequence similar to that
shown in Table 2.
Performance Route Processor Installation and Configuration Guide
Checking the Installation
Figure 7.)
27