Additional Configuration and Maintenance Tasks
Press Return.
Step 9
After some interface information displays, the prompt appears as follows:
Router>
Enter the enable command to enter enabled mode.
Step 10
The prompt changes to the following:
Router#
Enter the show start-up config EXEC command to display the enable password
Step 11
in the configuration file.
Enter the configure terminal command at the EXEC prompt.
Step 12
You are prompted as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Change the configuration register value back to its original value (noted from
Step
Change it to a value of 0x0102 (factory default) using the config-register 0x value
command.
Press Ctrl-Z or type end to exit configuration mode.
Step 13
Reboot the router and enable it using the recovered password.
Step 14
Performance Route Processor Installation and Configuration Guide
72
3.)
OL-11656-01