Table of Contents
Advertisement
VBAT
C1
10 μF
GPIO
VBAT
USB_VBUS
USB_DM
USB_DP
USB_ID
Module
Figure 12: USB Interface Reference Design (OTG Supported)
In order to ensure USB performance, comply with the following principles when designing the USB
interface.
⚫
Route the USB signal traces as a differential pair with total grounding. The impedance of USB
differential trace should be controlled to 90 Ω.
⚫
Keep the ESD protection devices as close as possible to the USB connector. Pay attention to the
influence of junction capacitance of ESD protection devices on USB data lines. Typically, the
capacitance value should be less than 2 pF.
⚫
Do not route signal traces under crystals, oscillators, magnetic devices or RF signal traces. Route the
USB differential traces in inner-layer with ground shielding on not only the upper and lower layers but
also the right and left sides.
⚫
Make sure the trace length difference between USB 2.0 differential data signals is less than 0.7 mm.
Table 13: USB Trace Length Inside the Module
Pin No.
Signal
13
USB_DM
14
USB_DP
SC200R&SC262R_Series_Hardware_Design
L1
4
SW
1.0 μH
5
VIN
1
EN
R1
10K
U1
C3
100 nF
GND
Length (mm)
32.25
32.15
7
VOUT
8
VOUT
C2
6
NC
22 μF/
10 V
D3
D4
D1
D2
ESD
ESD
ESD
ESD
Length Difference (DP - DM)
-0.10
Smart Module Series
1
VUSB
2
USB_DM
3
USB_DP
4
USB_ID
5
GND
49 / 124
Advertisement
Table of Contents
