Service Terminal - Honeywell Fire-Lite Alarms MS-9200UDLSE Manual

Master Programming Level
ON BOARD DACT

1=SERVICE TERMINAL

2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2
MS-9200UDLS PN 52750:A 11/04/05
3.6.9.2.4 Service Terminal
The MS-9200UDLS can be programmed remotely from a PC using a modem and
telephone line. Information can also be retrieved from the FACP using the same
method. The Upload/Download option allows an operator to set the necessary
parameters to allow the uploading and downloading of data between the FACP and
PC. The Service Terminal selection provides the means for entering these
parameters.
Pressing 1 while viewing On Board DACT Screen #2 will cause the following
screens to appear:
SERVICE TERMINAL
1=PANEL ID
2=TERMINAL 1
3=TERMINAL 2
Service Terminal Screen #1
SERVICE TERMINAL
1=RING COUNT
Service Terminal Screen #2
3.6.9.2.4.1 Panel ID
The Panel Identification Number is a 4-digit code (valid digits being 0 - 9 and A - F)
that is used to identify the installed FACP. It is important to program this code into
the FACP the first time that downloading is performed so that the called Service
Terminal can identify the control panel. The factory default is 0000.
To program the Panel ID, press 1 while viewing Service Terminal Screen #1. The
following screen will be displayed:
4 CHARACTER 0-F
Panel ID Screen
A flashing cursor will appear in the lower left corner of the display. Enter a 4-digit
code using the digits 0 - 9 and/or the letters A - F by entering the first character.
Press the right arrow key to move the cursor to the second position and enter the
second character. Follow the same procedure to enter the remaining characters.
After entering the fourth character, press the right arrow key and then press the
Enter key to store the Panel ID number.
0000
3
PANEL ID
Programming
99