Table of Contents
Advertisement
Overview
SECTION 7
7.1 Overview
7.2 Calculating the AC Branch Circuit
Device Type
MS-9200UDLS
or
MS-9200UDLSE
CHG-75
CHG-120F
MS-9200UDLS PN 52750:A 11/04/05
Power Supply Calculations
This section contains instructions and tables for calculating power supply currents in
alarm and standby conditions. This is a four-step process, consisting of the following:
1. Calculating the total amount of AC branch circuit current required to operate the
system
2. Calculating the power supply load current for non-fire and fire alarm conditions
and calculating the secondary (battery) load
3. Calculating the size of batteries required to support the system if an AC power
loss occurs
4. Selecting the proper batteries for your system
The control panel requires connection to a separate, dedicated AC branch circuit, which
must be labeled FIRE ALARM. This branch circuit must connect to the line side of
the main power feed of the protected premises. No other non-fire alarm equipment may
be powered from the fire alarm branch circuit. The branch circuit wire must run
continuously, without any disconnect devices, from the power source to the control
panel. Overcurrent protection for this circuit must comply with Article 760 of the
National Electrical Codes as well as local codes. Use 14 AWG (2.00 mm
600 volt insulation for this branch circuit.
Use Table 7.1 , to determine the total amount of current, in AC amperes (A), that must
be supplied to the system.
Table 7.1 AC Branch Circuit Requirements
Number of
Devices
1
[
]
[
]
[
]
Sum Column for AC Branch Current Required
Current Draw
(AC amps)
3.00
X
or
1.50
X
2.05
X
2.00
X
[
]
Power Supply Calculations
2
) wire with
Total Current
per Device
=
=
=
=
=
163
Advertisement
Table of Contents
