1: System Point - Honeywell Fire-Lite Alarms MS-9200UDLSE Manual

Read Status
4.22.1 System Point
READ STATUS
Pressing 1 while viewing Read Status Screen #1 will cause the following screen to be displayed:
1=SYSTEM POINT
2=ZONES
3=POWER
Read Status Screen #1
The operator selects the type of device which is to be viewed by pressing 1 for Detector or 2 for
Module. If 1 is pressed, the display will change to the following screen:
Entering the three digit detector address will cause the control panel to display the current status of
the selected device. For example, if a detector with address 001 on the SLC loop is entered, a
display similar to the following will appear:
The information in the preceding display includes:
MS-9200UDLS PN 52750:A 11/04/05
READ SYSTEM POINT
1=DETECTOR
2=MODULE
READ SYSTEM POINT
ENTER DETECTOR#
***
NORMAL SMOKE(PHOTO)
• NORMAL - the present status (could also be ALARM, TROUBL, DISABL, etc.)
• SMOKE (PHOTO) - the device type which is a photoelectric smoke detector (could also be
ION for ionization smoke detector)
• NORTH CLASSROOM - the Adjective/Noun label for this device
• Z005 - the first of five possible assigned software zones
• 1D001 - 1 = SLC Loop, D = Detector, 001 = Address 001
• V - Alarm Verification Enabled (V = Yes, * = No)
• S - Silenceable for control modules (S = Yes, * = No)
• W - Walktestable for control and monitor modules (W = Yes, * = No)
SELECT TYPE
NORTH CLASSROOM
Z005
V 1D001
Operating Instructions
141