Table of Contents
Advertisement
3
Input/Output Settings
Power Save Mode
Power Save Mode allows you to automatically set the conditions under which the scanner idles, sleeps, and wakes up. When
Off is selected, no power saving is used and the scanner remains powered on until the trigger is pressed.
When Sleep Mode is selected, the scanner goes into sleep mode (powered off) after the time interval set using
Mode Timeout
(page 3-1), during which there is no activity. This provides significant power savings over the Off setting.
When Hibernate Mode is selected, the scanner goes into idle mode after the time interval set using
(page 3-1), during which there is no activity. After the same time interval has elapsed with no activity while the scanner is in idle
mode, the scanner goes into sleep mode (powered off). This provides additional power savings over the Sleep Mode setting,
but the scanner takes longer to wake up.
Default = Off.
* Off
Hibernate Mode
Power Save Mode Timeout
Use this selection to set a timeout (in seconds) for the scanner when using Power Save Mode. When this time has
elapsed with no activity, the scanner will enter the Power Save Mode selected. After scanning the Power Save Mode
Timeout bar code, set the timeout duration (from 0-65535 seconds) by scanning digits on the
inside the back cover, then scanning Save. Default = 600 seconds.
Power Up Beeper
The scanner can be programmed to beep when it's powered up. Scan the Off bar code(s) if you don't want a power up beep.
Default = Power Up Beeper On - Scanner.
Power Up Beeper Off -
Scanner
Power Save Mode Timeout
Power Save
Power Save Mode Timeout
Sleep Mode Only
Programming Chart
3 - 1
Advertisement
Table of Contents
