Table of Contents
Advertisement
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have addenda. You must then turn on a 2 or
5 digit addenda listed on
page
Required
UPC-A Addenda Separator
When this feature is on, there is a space between the data from the bar code and the data from the addenda. When turned
off, there is no space. Default = On.
* On
Addenda Timeout
You can set a time during which the scanner looks for a coupon code. If a coupon code is not found within this time period,
the data can be either transmitted or discarded, based on the setting you are using for
Coupon Code
or
UPC-A Number System 4 Addenda
the bar code below, then setting the timeout (from 0-65535 milliseconds) by scanning digits from the
then scanning Save. Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-A Redundancy
If you are encountering errors when reading UPC-A bar codes, you may want to adjust the redundancy count. Redundancy
adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan the UPC-A
Redundancy bar code below, then scan a redundancy count between 0 and 10 on the
cover of this manual. Then scan the
6-26. Default = Not Required.
Required. Set the length (in milliseconds) for this timeout by scanning
Addenda Timeout
Save
bar code. Default = 0.
UPC-A Redundancy
* Not Required
Off
UPC-A/EAN-13 with Extended
Programming
Programming Chart
inside the back
Chart,
6 - 27
Advertisement
Table of Contents
