Table of Contents
Advertisement
Straight 2 of 5 IATA (two-bar start/stop)
<Default All Straight 2 of 5 IATA Settings>
Straight 2 of 5 IATA On/Off
On
* Off
Straight 2 of 5 IATA Redundancy
If you are encountering errors when reading Straight 2 of 5 IATA bar codes, you may want to adjust the redundancy count.
Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of
errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy,
scan the Straight 2 of 5 IATA Redundancy bar code below, then scan a redundancy count between 0 and 10 on the
Programming Chart
inside the back cover of this manual. Then scan the
Save
bar code. Default = 0.
Straight 2 of 5 IATA
Redundancy
Straight 2 of 5 IATA Message Length
Scan the bar codes below to change the message length. Refer to
Message Length Description
(page 6-1) for additional
information. Minimum and Maximum lengths = 1-80. Minimum Default = 13, Maximum Default = 15.
Minimum Message Length
Maximum Message Length
6 - 15
Advertisement
Table of Contents
