Table of Contents
Advertisement
Step 1. Scan the 1st Left Identifier bar code, below.
Step 2. Use the
Programming Chart
Step 3. Scan Save.
Step 4. Scan the 2nd Left Identifier bar code, below.
Step 5. Use the
Programming Chart
Step 6. Scan Save.
Step 7. Scan the 1st Right Identifier bar code, below.
Step 8. Use the
Programming Chart
Step 9. Scan Save.
Step 10. Scan the 2nd Right Identifier bar code, below.
Step 11. Use the
Programming Chart
Step 12. Scan Save.
Once you have programmed the concatenation sequence, use
enable this feature. Default = 0.
1st Left Identifier
1st Right Identifier
ISBT 128 User-Defined Concatenation Sequences On/Off
The following selections allow you to enable or require the User-Defined ISBT 128 Concatenation Sequences.
If you scan Off, the User-Defined concatenation sequences are disabled.
If you scan the Allow User-Defined Sequence code, then the scanner will output only the data combination specified in
the User-Defined concatenation sequence you created.
If you scan the Require User-Defined Sequence code, the data combination specified in the User-Defined concatenation
sequence is required to transmit the data. No data is output unless the sequence is read.
Default = Off.
* Off
to scan 3, D (hex for "=").
to scan 4, 7 (hex for "G").
to scan 3, D (hex for "=").
to scan 3, C (hex for "<").
ISBT 128 User-Defined Concatenation Sequences
to
2nd Left Identifier
2nd Right Identifier
6 - 21
Advertisement
Table of Contents
