Table of Contents
Advertisement
UPC-E0 Leading Zero
This feature allows the transmission of a leading zero (0) at the beginning of scanned data. To prevent transmission, scan
Off. Default = Off.
On
UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data. Default = Off for both 2 Digit and 5 Digit Addenda.
2 Digit Addenda On
5 Digit Addenda On
UPC-E0 Redundancy
If you are encountering errors when reading UPC-E0 bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan
the UPC-E0 Redundancy bar code below, then scan a redundancy count between 0 and 10 on the
inside the back cover of this manual. Then scan the
Save
bar code. Default = 1.
UPC-E0 Redundancy
* Off
* 2 Digit Addenda Off
* 5 Digit Addenda Off
Programming Chart
6 - 33
Advertisement
Table of Contents
