Table of Contents
Advertisement
Working Standard
User's Guide
Setting the auto range in accessory connected to input A.
Parameter is: 0 = OFF, 1 = ON.
CHNLB:AC:RANG?
Request for the range in accessory connected to input B.
Answer can be 0, 1 ... (up to supported number of ranges).
CHNLB:AC:RANG {<range>}
Setting the measurement range in accessory connected to input B.
Parameter can be 0, 1 ... (up to supported number of ranges).
CHNLB:AC:RANG:AUTO?
Request for the status of auto range in accessory connected to input B.
Answer is: 0 = OFF, 1 = ON.
CHNLB:AC:RANG:AUTO {<auto_range>}
Setting the auto range in accessory connected to input B. Parameter is: 0 = OFF, 1 = ON.
MEAS:VOLT:AC?
Request for voltage values.
MEAS:VOLT:AC:PRIM?
Request for primary voltage values.
MEAS:VOLT:AC:PHAS?
Request for phases between voltages.
MEAS:VOLT:AC:SUM:SQ?
Request for sum of square voltages.
MEAS:VOLT:AC:DIST?
Request for the distortion of measured voltage.
MEAS:VOLT:AC:TR:RAT?
Transformer Test: Request for the measured transmission ratio of separate voltage channels (r
).
Lx/L1
MEAS:VOLT:AC:TR:ERR?
Transformer Test: Request for the calculated transmission error of separate voltage channels (er
).
Lx/L1
MEAS:VOLT:AC:TR:PHAS?
Transformer Test: Request for the measured phase error of separate voltage channels (φ
).
Lx/L1
MEAS:VOLT:AC:TR:RNOM?
Transformer Test: Request for the nominal transmission voltage ratio.
MEAS:VOLT:FREQ?
Request for the measured voltage frequency value.
MEAS:CURR:AC?
Request for current values.
MEAS:CURR:AC:PRIM?
Request for primary current values.
www.appliedp.com
87
WS-UGFW619-EN
Advertisement
Table of Contents
