Applied Precision WS 2120 User Manual page 85

Working Standard
User's Guide
Measuring Accessory Related Commands
Commands to read out serial numbers and types of measuring accessory connected to the device.
SYST:INPA:SERN?
Request for the serial number of accessory connected to Input A (In A).
SYST:INPA:TYPE?
Request for the type of accessory connected to Input A (In A).
SYST:INPB:SERN?
Request for the serial number of accessory connected to Input B (In B).
SYST:INPB:TYPE?
Request for the type of accessory connected to Input B (In B).
SYST:INP:CONF:STAT?
Request for inputs changing status. Answer is 0 when the configuration has been changed (stable
state), and 1 when the configuration is being changed (in progress).
SYST:INP:CONF {<x>}
Setting the measuring inputs combination. Parameter can have the following values:
x=0 when only internal voltage and current is being measured, regardless of connected measuring
accessory
x=1 when accessory connected to Input A is measured together with internal voltage
x=2 when accessory connected to Input B is measured together with internal current
x=3 when only accessories connected into Inputs A and B are measured, regardless of generated
voltage or current
These measured values are shown on blue screens and corresponding blue type screens are visible
for each particular combination: Load Values when U and I are measured together, U+U screens when
voltages only are available, etc.
SYST:INP:CONF?
Request for inputs configuration. Answer can be 0 ÷ 3 with the same description as for previous (setting)
command.
Results Reading Commands
RES:COUN:EMER?
Request for number of stored meters.
RES:COUN:LP? {<emer (1-255)>}
Request for number of stored load-points of defined meter.
RES:GET:EMER? {<emer (1-255)>}
Request for all header data of defined meter.
RES:GET:LP? {<emer (1-255)>},{<lp (1-255)>}
Request for all load-point data of defined meter and load-point.
RES:CLR
Clearing of all results (stored meters data).
www.appliedp.com 85
WS-UGFW619-EN