Table of Contents
Advertisement
Input Power
Voltage ................ 115 – 230 V ±10%, 50 - 60 Hz,
550 VA max.
Operating ............ IEC 61010-1:2010, IEC 61010-2-
030, CAT II, Pollution Degree 2
To ensure safety avoid the use of device in environment, where rain, excessive dust, excessive heat
may occur and other environments that can compromise the safe use of the device.
© 2020 Applied Precision Ltd. All rights reserved.
Product specifications are subject to change without notice. All product names are trademarks of their
respective companies.
Country of Origin: Slovakia
A Warning identifies conditions and procedures that are dangerous to the user.
A Caution identifies conditions and procedures that can cause damage to the Product or the equipment
under test.
To prevent possible electrical shock, fire or personal injury:
• To ensure safety only authorized and properly
trained personnel may use the Product and its
accessories and only for their intended purpose
• Read all safety information before you use the
Product
• Carefully read all instructions.
• Do not use this Product around explosive gas,
vapour, or in damp, wet or dusty environments
• Use only original power adapter
• Examine the case before you use the Product.
Look for cracks or missing plastic. Carefully
look at the insulation around the terminals.
• Do not open the Product, user can only open the
accumulators' cover in order to exchange them
• Do not use the Product if it operates incorrectly
• Remove the input signals before you clean the
product
• Do not use the Product outside its operational
temperature range
• Do not touch voltages > 30 Vac rms, 42 Vac peak,
or 60 Vdc
www.appliedp.com
1.1 Safety Specification
1.2 Safety Information
Warnings
WS-UGFW619-EN
Temperature
Operating ........ -10 °C to 40 °C
Relative Humidity
Operating ......... ≤95 % at Ta ≤25 °C
Altitude
Operating ......... 2000 m max.
• Use only cables with correct voltage ratings
• Inspect the output binding posts prior to use.
Repair broken or loose output binding posts
before use.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised
• Whenever it is likely that safety protection has
been impaired, the Product must be made
inoperative
and
unintended
operation.
maintenance
or
repair
protection is likely to be impaired if, for
example, the Product shows visible damage or
fails to operate normally.
• Only authorized service centre may carry our
repair tasks
• Accessory shall be connected to the Product
only when the Product is turned off. Always
use only original accessories.
Working Standard
User's Guide
secured
against
Inform
qualified
personnel.
Safety
any
5
Advertisement
Table of Contents
