Slave Address Erasure - Mitsubishi Electric QJ71AS92 User Manual

4 SETTINGS AND PROCEDURES FOR OPERATION

4.5.3 Slave address erasure

CODE
MODE
SET
Press the SET switch
for more than five seconds.
CODE
MODE
SET
Slave address 0 is set.
4 - 13
Downloaded from ManualsNet.com
This section describes the procedure of assigning the slave address 0 to the slave with
No.10.
Following is the example when the slaves of slave No.1 and 2 have been registered.
(1) Put the QJ71AS92 in the configuration mode, by reference Section 4.5.1 (1). All
the slave addresses recognized in the AS-i system are displayed on the CODE
A
B
LED in order.
A
B
A
B
(2) When the slave No.10 is displayed, press the SET switch for more than five
seconds. This sets slave address 0 to the slave.
A
B
("0" is stored into the nonvolatile memory of the slave.) At the same time, "0"
appears on the CODE LED of the QJ71AS92.
A
B
(3) When you release the SET switch, the CODE LED displays the slave address
of the slave that has been recognized again.
A
B
A
B
A
B
search engine
MELSEC-Q
4 - 13