FX2N-32ASI-M AS-interface Block
6.2.2
Programming the Slave Address
This operation assign an available address to slave with address 0.
1) The addresses of all recognized slaves are displayed one after the other.
2) To display the next higher available operating address, press the "SET" button. Each time
pressing the "SET" button, the next available address is displayed.
If "SET" or "MODE" button is not pressed for 10 seconds or more, 32ASI-M returns to the
state of the display of 1).
3) Set the displayed address as the target address by pressing the "SET" button for more than
5 seconds.
4) The address display blinks.
5) Pressing the "SET" button again reprograms a connected slave with address 0 to the
blinking address.
6) If error code did not display, the displays the list of detected slaves again as described. If
error code displayed, see Section 6.4.
7) For the operation of a set end, refer to 6.1.1.
Configuration Mode and Protected Operating Mode 6.
6-4