Individually Acknowledging Supervisory Conditions - Simplex InfoAlarm 4100U Operator's Manual

6.1.3

Individually Acknowledging Supervisory Conditions

If individual acknowledge is enabled on your system, you need to separately acknowledge each supervisory condition. Use the following
procedure to do this.
1. Unlock and open the enclosure door. The display shows the supervisory condition, similar to Figure 21.
2. Press the SUPV ACK key. Repeat this step and read the reports. The display shows the area and type of condition. The tone-alert
silences and the yellow LED glows steady.
3. Read the display. Investigate the problem to determine its cause.
When the problem causing the condition is corrected, the SUPERVISORY LED flashes and the tone-alert sounds steady.
1. Press the SUPV ACK key. The display shows the system status.
2. Press the SUPV ACK key again. After a short delay, the display indicates that the system is normal.
page 20
InfoAlarm Operator's Manual 4100U, 4100ES, 4010ES
579-685 Rev. D