Troubleshooting - BeefEater Discovery 1100 Series Assembly And Operating Instructions Manual

Built-In BBQs

Troubleshooting

Condition
Flame goes out while in use
Ignition failure
Foul smell of gas
Flame appear to separate off the
burner or flame burns with noise
Yellow Tipping in Flame
1100series Ins_EU_V0
12
Build-In brackets are required
to be attached to BBQ before
it can be positioned in
brickwork.
Installation must be done by a
qualified person!
Depth
Possible Cause
Empty Gas cylinder.
Air mixed in hoses.
Blockage
gas cylinder valve close
Air mixed in the hoses
Rubber hose wrapped, deformed or
pinched
Spark Escaping
No Spark
Damage to hose
Leakage
Burner went off
Incorrect combustion
blockage of burner Ports
Air/Gas mixture screw in burner
incorrect
Dimension
Width [mm]
Height (Min)
(not including 30mm clearance at rear)
Clearance at rear (Min)
Minimum clearance to combustible
materials
Replace cylinder.
Re-ignite and allow operating for a
short while, till clears out
Seek professional assistance.
Turn off knob button, then open the
cylinder valve
Re-ignite and allow operating for a
short while, till clears out.
Release hose, ensure not damaged
or leaking
Ensure the spark probe is in place,
not deformed, clean.
Seek professional assistance.
Turn cylinder valve off, replace
hose.
Leak-test, and tighten where
required.
If leakage can't be rectified, cease
using appliance, and seek
professional assistance
Shut off valves, wait for 5 minutes
and reignite
Seek professional assistance
Clean the burner thoroughly.
If problem persists, Seek
professional assistance
Try to open screw to remove yellow.
If not changing, seek professional
assistance
#3 #4
720 880
280 (11")
540 (22")
30 (1¼")
450 (18")
Solution
#5
1035