Gas Connection; Service Assistance - BeefEater Discovery 1100 Series Assembly And Operating Instructions Manual

Gas Connection

The manifold to connect this barbecue is located under the front fascia, on the right-hand-side.
The manifold entry is a is 3/8" SAE type male flare thread.
Some of our distributors include a Regulator with the Barbecue. If a regulator is included with your
Barbecue, the hose of the regulator is connected to the manifold, using a 19mm spanner to manifold entry
marked number 'A'*
A view from
rear, bottom
of Barbecue
If your distributor does not include a regulator, BeefEater will supply a Nut-and-Tail fitting for your use.
Tighten the fitting over manifold inlet 'A'* using a 19mm spanner, and then slip the hose of your
regulator over the nozzle and tighten with a hose-clamp:
A view from
rear, bottom
of Barbecue
Note: After making the gas connections, ensure to conduct a thorough Leak-Test, as explained in page 4.
Natural Gas or LPG/Propane.
Before beginning installation or assembly, check that the gas type which the barbecue is designed for is
correct for the gas available to you. In most countries the choices are natural gas or LPG/propane. You will
find the gas type label on the side of your barbecue. If your barbecue uses the incorrect gas type, or if
you are unsure, consult your dealer before going any further. Using the wrong type of gas for a barbecue
is extremely dangerous.
Natural Gas Conversion: Most newly purchased barbecues are made for LPG/propane. A natural gas
conversion kit is available to allow your barbecue to run on Natural Gas. This kit includes all hoses
required for installation, and available for purchase from your nearest BeefEater dealer.

Service Assistance:

To assist you when contacting your after-sales service agent and to arrange for service, please have the
barbecue details ready when you call. You do not need to register your warranty. However, you must
retain your receipt or proof of purchase. When claiming warranty for this appliance you must provide a
copy of your proof of purchase receipt. No claims for warranty will be accepted without proof of purchase.
For all parts and service, contact your nearest BeefEater dealer.
10
*
Ensure inlet
'B' remains
plugged and
sealed unless
opening to
connect Side-
Burner.
*
Ensure inlet
'B' remains
plugged and
sealed unless
opening to
connect Side-
Burner.