CONGRATULATIONS CONTENTS Dear customer, General warnings ��������������������������������������������������������������������������3 Integrated barbecue product description �������������������������������������4 Congratulations and thank you for choosing our barbecue� Parts �����������������������������������������������������������������������������������������������5 We are sure you will find it a pleasure to use� Before you use the barbecue, we recommend that you read through the Gas specifications ��������������������������������������������������������������������������6 relevant sections of this manual, which provide a description Leak test procedure ����������������������������������������������������������������������7...
IMPORTANT SAFETY INSTRUCTIONS Please read the user manual carefully and store in a handy place for later reference� WARNING WARNING • Do not lean over barbecue when lighting. TIPS & INFORMATION • Do not leave the barbecue unattended when alight. IMPORTANT •...
Cast Iron Hotplate Removable oil reservoir located at front of cooking surface (not illustrated) Flame tamers x 2 located under grills (not illustrated) Integrated barbecue with roasting hood BSH158SA Roasting hood Warming racks Battery cover Gas connection point Burner controls...
PARTS DESCRIPTION DESCRIPTION Rear heat Natural gas shield regulator and installation pipe Flame Universal tamers LPG hose and regulator assembly Oil reservoirs 1 Plastic bag, containing this instruction book, labels, 1 fibre washer, match holder and chain EITHER Roasting hood Cast Iron and base plate...
GAS SPECIFICATIONS Natural gas installation NATURAL UNIVERSAL GAS TYPE PROPANE This barbecue is set up for Natural Gas and is labelled Maximum gas 67�2 MJ/h 64�0 MJ/h 71�0 MJ/h accordingly� A Universal LPG and Propane conversion kit is consumption included if required� Injector office 1�75mm 0�90mm...
LEAK TEST PROCEDURE Leak test procedure • Ensure all gas valves are in the ‘OFF’ position� • In a small container, mix a solution of water and detergent or soap� • After connection of the hose, turn on the gas supply at the gas bottle or mains as appropriate�...
UNIVERSAL LPG AND PROPANE INSTALLATION NOTE: Conversion of this unit to Universal LPG or Propane must be carried out by a qualified licensed person and a Remove burner to Certificate of Compliance must be issued to the owner on access injector completion of the installation and conversion�...
Page 9
UNIVERSAL LPG AND PROPANE INSTALLATION This barbecue is set up for Natural Gas and is labelled Gas bottle safety information accordingly� A Universal LPG or Propane Gas conversion Kit • This appliance is designed to use a 9kg (20 lbs) is supplied if required�...
UNIVERSAL LPG AND INSTALLATION WARNINGS PROPANE INSTALLATION WARNING WARNING • This appliance may be installed outdoors, under cover, or in an outdoor kitchen or outdoor living area. • Outdoor areas where this appliance is located may be enclosed by blinds, partitions or similar for the Barbecue gas inlet purpose of weatherproofing.
INSTALLATION INSTRUCTIONS Installation warnings Choosing a location The mounting enclosure When planning the location and preparing the installation • The barbecue requires a non-combustible barrier under structure for this appliance note the following: the barbecue to prevent excessive temperatures being accessed�...
Page 12
DIMENSIONS Benchtop must be non- This side wall can be combustible material combustible material 250 min 250 min Non-combustible barrier – at least 30mm between barrier and This side wall can be base of the appliance combustible material 71mm minimum from cutout This front wall can Benchtop...
DIMENSIONS WARNING! This appliance requires venting. An open area as indicated must be allowed for. A suitable grille can be fitted if desired. This vent area is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion.
GAS REQUIREMENTS ASSEMBLING THE BARBECUE Natural Gas requirements 1� Remove all components from box� 2� Attach heat shield to rear of unit by inserting the • The enclosure must be constructed so that access can three top tabs into the rear holes and sliding the be gained to the Natural Gas regulator at all times�...
HOTPLATE CONFIGURATION Install hotplates and grills as shown, ensuring that the flame tamers are located under the grills. NOTE: ensure that grill assemblies are orientated correctly so that the surface of the grill is sloping forward to allow oil to drain into oil reservoirs�...
OPERATING INSTRUCTIONS Control functions Preheating Before lighting the barbecue: For best cooking results it is recommended to preheat the barbecue prior to cooking� • Check that all hoses and gas fittings are tight� • This barbecue is fitted with high power burners� In •...
LID SAFETY – SLIMLINE ONLY CLEANING AND CARE The BeefEater Integrated barbecue has been constructed To ensure that the user remembers to turn off the gas before from select grade stainless steel which, if not cared for, may closing the lid, a pivoting safety leg has been fitted�...
Page 18
In these conditions BeefEater strongly recommends cleaning and drying your barbecue after every use and covering it when not in use to minimise exposure to the elements� Surface corrosion can be removed by using a specialized stainless steel cleaner�...
MAINTENANCE The ignition system To change the battery rotate the cover anti-clockwise to release� Lift off the cover to access spring and battery� Lift out the spring and battery� Replace with a new AA battery and replace the cover� Test by depressing the knob and an audible ‘clicking’...
* Replace battery� weatherproof cover Manually light the (for model BSH158SA and BSL158SA) barbecue� + Standard inclusion with the product but can also be purchased Ignition Gently clean and dry separately via the Electrolux Customer Service Centre�...
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BEEFEATER SIGNATURE BARBECUE 7. You may not make a claim under this warranty unless the defect claimed is This document sets out the terms and conditions of the product due to faulty or defective parts or workmanship. Electrolux is not liable in the warranties for Electrolux Appliances.
Page 24
For more information on all Beefeater products, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 307 939 fax: 1800 356 669 email: customercare@electrolux.com.au web: beefeaterbbq.com...