Mitsubishi Electric KD Series User Manual page 68

4-3-1 Communication control block diagram
ＣＩＳ
Control signal for Register
Sync signal
Control signal
for Register
Control board
Return signal
Control signal
External sync signal
Control signal for Register
CoaXPress
6.25Gbps×４
ＰＣ
【Communication port connectors】
L3 (KD6R807CX)
D1 Master port
TM-XH719C
4-3 Communication control (overview)
L1:367mm L2:587mm
CoaXPress I/F board
XML file
CoaXPress I/F board
（Master）
D1 D2 D3 D4
D5
CoaXPress CoaXPress
Grabber board
Grabber board
（Slave block）
（Master block）
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【Communication control 】
L2 and L3 types have two signal blocks for CoaXpress® ,
L3:807mm
and the 1
block. Main functions of the CIS can be controlled through
the D1 of Master block.
In case of using of the external sync mode, input trigger
signal to the 1
internal sync. mode.)
Slave block (Connector D5 to D8) is mainly used only to
change settings related to link control of CoaXpress® .
When you change a part of register values in Master block,
you need to change the part of register values in Slave
block. (Register information used for the Slave system is
XML file stored on the CIS as XML file for the Slave)
（Slave）
【Line sync signal 】
D6 D7 D8
1. External sync. mode
External sync signal, input through communication port, is
distributed to the other block inside CIS. The line data from
each block is synchronized at line scan basis.
2. Internal sync mode
Sync signal created inside CIS is distributed to the other
block inside CIS. The line data from each block is
synchronized at line scan basis.
【Remarks】
1) CIS can be controlled only through Master port. (Signal
through the other ports will not be reflected to CIS)
2) Confirm where to be connected from your Grabber board.
signal block (Connector D1 to D4) is the Master
st
Master port (D1). (No input required for the
st
68